Checks Before Installation; How To Remove Panels - Hoshizaki KM-520MAJ-E Instruction Manual

B. Checks Before Installation
• Visually inspect the exterior of the shipping container and immediately report any
damage to the carrier. Upon opening the container, any concealed damage should also
be immediately reported to the carrier.
• Remove the shipping carton, tape, and packing material. If any are left in the icemaker,
it will not work properly.
• See the nameplate on the rear panel, and check that your voltage supplied corresponds
with the voltage specified on the nameplate.
• Remove the panels to prevent damage when installing the icemaker. See "II.C. How to
Remove Panels."
• Remove the package containing the accessories.
• Remove the protective plastic film from the panels. If the icemaker is exposed to the sun
or to heat, remove the film after the icemaker cools.
• Check that the refrigerant lines do not rub or touch lines or other surfaces, and that the
fan blade (if applicable) turns freely.
• Check that the compressor is snug on all mounting pads.
• The icemaker can be installed on a dispenser unit or ice storage bin. The ice storage
bins listed below are recommended.
Model Number Bin Width
KM-520MAJ-E
KM-660MAJ-E
For further options, contact your local Hoshizaki distributor.
C. How to Remove Panels
See Fig. 1
• Front Panel: Remove the screw. Lift up and
towards you.
• Top Panel: Lift up at front slightly, push rearward
and lift off.
• Right Side Panel: Remove the screw. Slide the
right front corner to the right slightly, then push
rearward and lift off.
• Front Insulation Panel: Lift up slightly and pull
towards you.
• Base Cover: Lift up slightly and pull towards you.
Recommended Hoshizaki Ice Storage Bin
22" or Wider B-300 Series
Front Insulation Panel
Front
Panel
Model Shown: KM-520MAJ-E
9
Top Panel
Screw
Right Side Panel
Base Cover
Fig. 1