Boot Sequence; Disc To Disc Recovery Enable; Password; Using Software - Acer 3000 User Manual

40

Boot sequence

To set the boot sequence in the BIOS utility, activate the BIOS utility,
then select "Boot" from the categories listed at the top of the screen.

Disc to disc recovery enable

To enable disc to disc recovery (hard disc recovery), activate the BIOS
utility, then select "Main" from the categories listed at the top of the
screen. Find "D2D Recovery" at the bottom of the screen and use the
F5/F6 keys to set this value to "Enabled".

Password

To set a password on boot, activate the BIOS utility, then select
"Security" from the categories listed at the top of the screen. Find
"Password on boot:" and use the F5/F6 keys to enable this feature.

Using software

Playing DVD movies

When the DVD drive module is installed in the optical drive bay, you
can play DVD movies on your computer.
1 Eject the DVD tray and insert a DVD movie disc; then close the
DVD tray.
Important! When you launch the DVD player for the first time, the
program asks you to enter the region code. DVD discs are divided
into 6 regions. Once your DVD drive is set to a region code, it will
play DVD discs of that region only. You can set the region code a
maximum of five times (including the first time), after which the
last region code set will remain permanent. Recovering your hard
disc does not reset the number of times the region code has been
set. Refer to the table below for DVD movie region code
information.