Advertisement
Breaking in Air compressor
1. Turn Power Switch OFF
and remove battery pack.
2. Fully open Drain Valve.
3. Insert fully charged Battery Pack(s).
4. Turn Power Switch ON.
Air connection Setup
1. Connect 1/4" NPT air hose (sold separately)
to the Air Outlet. The air hose must be long
enough to reach the work area with enough extra
length to allow free movement while working.
• Using PTFE tape, connect 1/4" industrial
fittings (sold separately) to air hose.
to compressor
Air plug
Operating instructions
Read the EntiRE iMpORtAnt SAFEty inFORMAtiOn section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
Work Area Set Up
1. Designate a work area that is clean and well-lit.
The work area must not allow access by
children or pets to prevent injury.
General Operation
1. Close Drain Valve.
2. Close Regulator.
3. Turn Power Switch OFF.
4. Insert fully charged Battery Pack(s).
5. Turn Power Switch ON.
6. Allow Air Compressor to build up
pressure until it cycles off.
note: At beginning of the day's first use, check for
air leaks by applying soapy water to connections
while Air Compressor is pumping and after pressure
cut-out. Look for air bubbles. If air bubbles are
present at connections, tighten connections. Do not
use Air Compressor unless all connections are air
tight, extra air leaking out will cause Air Compressor to
operate too often, increasing wear on Air Compressor.
Item 57394
to Air tool
coupler
For technical questions, please call 1-888-866-5797.
5. Let unit run for 30 minutes. Air will expel freely
through the Drain Valve.
6. Turn Power Switch OFF.
7. Remove Battery Pack(s) and close Drain Valve.
2. Connect 1/4" industrial plug (included) to coupler.
to coupler
2. Locate the Air Compressor on a flat level surface
to ensure proper pump lubrication and to prevent
damage to the unit. Keep at least 12" of space
around the unit to allow air circulation.
note: As long as Power Switch is ON, operation of
Air Compressor is automatic, controlled by an internal
pressure switch. Air Compressor will turn on
automatically when air pressure drops to 105 PSI,
and will turn off automatically when air pressure reaches
135 PSI.
WARninG! tO pREVEnt SERiOUS
inJURy AnD DEAtH FROM
EXplOSiOn:
Do not adjust the internal
pressure switch. Any change to the
automatic pressure levels may cause excess pressure to
accumulate, causing a hazardous situation.
to Air tool
Page 7
Advertisement
