Advertisement
...you want to check the dryer yourself first: (If your machine is not functioning correctly, please
check the following points before calling the customer service - also refer to relevant chapter in the
instructions for use)
Drying takes too long/
Laundry is not dry enough
The dryer does not
operate (after a power
failure, always press the
"Start (Pause)" button)
Door filter, water
container or bottom filter
indicator lamp on
Water droplets
underneath the dryer
...you want to care of and clean your dryer:
Clean the filter at the end
of every cycle
Empty the water container
at the end of every drying
cycle
Clean the bottom filter
every fifth cycle
HOW TO PROCEED IF...
• Has the correct drying programme been selected?
• Was the inserted laundry too wet (washing machine spin speed less than
1000 rpm)?
• Is the door filter dirty (filter indicator light on)?
• Is the bottom filter dirty (for more information, refer to the instructions for use)?
• Is the room temperature too high?
• Are the "End" and "Anticrease" indicator lamps lighting up? The drying cycle
is complete and the laundry can be taken out.
• If the drying result does not meet your expectation, select a drier
programme. You can use the dryness adjustment option (if available) to
optimize the drying results.
• Is the plug properly inserted into the mains electricity socket?
• Is there a power failure?
• Has the fuse blown?
• Is the door properly closed?
• Has a drying programme been selected?
• Has the "Start (Pause)" button been pressed?
• Has the start delay option been selected?
• Is the dryer overloaded?
• Is the door filter clean?
• Is the water container empty?
• Has the water container been inserted correctly?
• Is the bottom filter clean and inserted correctly?
• Has the bottom filter been inserted correctly?
• Have all lint on the bottom filter seal and the door seal been wiped away?
• Has the water container been inserted correctly?
• If the direct drain connection is used, is it tight?
• Is the dryer levelled?
• Brush lint using a soft brush or your fingertips.
• Close the filter.
• Push the filter back into place.
• Pull the handle to remove the water container.
• Empty the water container.
• Replace the water container when empty by pushing it completely back in place.
• Clean the bottom filter under running water.
• Remove all fluffs from the seals.
• Clean the bottom filter housing (for further information see chapter
"Cleaning the Bottom Filter" in the Instructions for Use).
• See the instruction for use for further information how to clean the bottom
filter.
Please remove a part of the load.
3
Advertisement
