Samsung WF231ANW/XAA User Manual page 17

2. Before connect the inlet hoses to water faucets, check to
ensure a washer is inside each coupling on both ends.
3. Check the inlet hose to ensure a washer is inside each fi ll
hose coupling.
Thread the inlet hoses to the HOT and COLD faucet
connections on the washer.
On the other end of the hose, check for one rubber washer
per hose and attach each fi ll hose to the water valve. Make
sure the hose with the Hot printed line is attached to the
HOT faucet. Tighten by hand until snug, then two-thirds of a
turn with pliers.
For correct water use, connect both HOT and COLD water
valves. If either or both are not connected, an "nF" (no fi ll)
error can occur.
4. Turn on the HOT and COLD water supply and check all
connections at the water valve and the faucet for leaks.
5. Plug the power cord into a 3-prong, well grounded 120 volt
60 Hz approved electrical outlet protected by a 15-amp fuse
or comparable circuit breaker.
Your washer is grounded through the third prong of the power
cord when plugged into a three-prong grounded receptacle.
6. Slide your washer into position.
7. Level your washer by turning the leveling legs in or out as
necessary by hand or by using the wrench included with your
washer.
When your washer is level, tighten the locking nuts using the
wrench or (-) fl athead screwdriver.
Your washer must be leveled on all four sides. A carpenter's
level should be used on all four corners of your washer. It's
the best to recheck after the fi rst dozen washes.
Avoid damage to the legs. Do not
move the washer unless the locking-
nuts are fastened to the bottom of the
washer.
WF231ANW-02832D_EN.indd Sec5:17 WF231ANW-02832D_EN.indd Sec5:17
Coupling Rubber
Washer
Cold Hot
Cold printed Hot printed
setting up your washer _17
2011-04-18 2011-04-18 10:38:14 10:38:14