Figure 3: Parameter Menu - Gastrofrit TW-350 Instruction Manual

5. Operation
5.1. Customer parameters
Certain parameters can be changed by the customer.
5.1.1. Call up the parameter menu
If the machine is in the OFF state, you can switch to the parameter menu by pressing the key
seconds.
5.1.2. Change parameter pages
The various parameter pages can be called up with the key
5.1.3. Change parameters
The parameters can be changed with the keys
5.1.4. Exit the parameter menu and save the new values
To exit the parameter menu, press the key
The changed values are saved and are retained even in the event of a power failure.
5.1.5. Example of the parameter menu

Figure 3: Parameter menu

5.1.6. Modifiable parameters
•
Sound-Level:
The volume of the buzzer can be changed between 0 (off ) and 10 (very loud).
•
Standby- time:
The standby time for the TW can be set between 5 and 120 minutes. If the "-" button is pressed for 5 min-
utes, the standby mode is switched off (Off )
•
Standby- temperature:
The standby temperature of the TW can be changed between 30 and 80 ° C.
•
Monitoring drying cycle:
After switching on, the temperature must not rise more than the set temperature difference (10-80 ° C) for
the first 60 seconds. If the temperature rises more, an error message is output (too little water / oil) and
the control goes into the off state.
•
Temperature limit for the clean function:
If the temperature is higher than this set temperature, the clean function is blocked.
11_Operation manual Pastacooker Gastro 8 V1_3_e
.
and .
.
Page of 7 19
or for 10
Rorschach, 19.03.2018