Table of Contents
Advertisement
INSTALLATION
1. Remove all parts from inside the stove body including touch up paint, fire poker, etc.
Loose fire bricks must be placed correctly before install (See Brick Install Section. Baffle
board must be place correctly and slid to the back of the stove wall with no gaps.)
2. Select the proper location for the stove. These appliances must not be installed any closer
than the minimum clearance to combustibles. (See State and county regulations)
3. The stove must be installed on a non-combustible surface w/ 16" in front of the door
4. If non-combustible materials have been installed on the walls, obtain the minimum
clearances from either the manufacturer of these materials or the local building inspector's
office.
5. Install the stovepipe INSIDE the flue collar on the top of the stove, between the stove and
the chimney, seal with high temp 2000-degree stove pipe sealant. Attach mounting screws
in holes provided in flue collar.
6. DO NOT use a grate to elevate the fire inside the firebox.
7. A minimum clearance of 18 inches (18") between the single wall stove pipe and
combustible materials is required. Check with authorities having jurisdiction in your area
with any questions.
8. All the pipe sections MUST BE connected with the male (crimped) end toward the stove.
9. Fasten the stove pipe to the flue collar using three sheet metal screws. Do the same at
each additional joint to make the entire installation rigid. Seal Single wall Joints.
10. Maintain the required diameter flue for the entire installation according to local rules
and regulations.
11. It is recommended that no more than two 90-degree bends be used in the stovepipe
installation. More than two 90-degree bends may decrease the amount of draw, and
possibly cause smoke spillage.
45-degree elbows are preferred.
12. An inline damper is not required in this installation. Remove the damper plate in the
chimney or secure it in the OPEN position. FAILURE TO FOLLOW THE MINIMUM CLEARANCE
REQUIREMENTS MAY RESULT IN AN UNSAFE INSTALLATION.
13. Single wall flue pipe assemblies must not exceed 12 feet (12') in overall length.
14. ALWAYS Check for Leaks
FRESH OUTSIDE COMBUSTION AIR IS HIGHLY RECOMMENDED.
Advertisement
Table of Contents
