509 Fabrication 5095-1 Manual page 3

Steelhead camp stove
Table of Contents

Advertisement

HOT
WHILE IN OPERATION. KEEP CHILDREN, CLOTHING AND FURNITURE AWAY. CONTACT MAY CAUSE
SKIN BURNS. DO NOT BURN GARBAGE OR FLAMMABLE FLUIDS.
1. Check with the building inspector's office for compliance with local codes; a permit may be required,
even though this is a recreational stove.
2. A 6" diameter flue is required for proper performance. Minimum Height of stack 8ft. (Will Vary With
the Elevation where the stove is installed, you may need more chimney)
3. Always connect this unit to a chimney and NEVER vent to another room or inside a building.
4. DO NOT connect to any duct work to which another appliance is connected, such as a furnace.
5. DO NOT connect this unit to a chimney flue serving another appliance.
6.
DO NOT USE CHEMICALS OR FLUIDS TO START THE
7. The connector pipe and chimney should be inspected periodically and cleaned if necessary.
8. Remember the clearance distances when you place furniture or other objects within the area.
DO NOT
store wood, flammable liquids or other combustible materials too close to the unit.
9. Contact your local fire authority for information on how to handle a chimney fire. Have a clearly
understood plan to handle a chimney fire. In the event of a chimney fire, turn air control to a closed
position and CALL THE FIRE DEPARTMENT.
10. DO NOT tamper with the combustion air control beyond normal adjustment.
11. Once the required draw is obtained, operate only with door closed; open feed lid slowly when
refueling.
12. Clean the stove glass before lighting the stove.
15. Visit our web site at 509Stoves.com or call us at 509-993-3767
ALWAYS PROVIDE A SOURCE OF FRESH AIR INTO THE ROOM WHERE THE UNIT IS INSTALLED. FAILURE TO
DO SO MAY RESULT IN AIR STARVATION OF OTHER FUEL BURNING APPLIANCES AND THE POSSIBLE
DEVELOPMENT OF HAZARDOUS CONDITIONS.
Note on Outside Air
Hookup: We highly recommend fresh air for tiny spaces. This involves connecting
an aluminum flex pipe (usually three inches (3") in diameter from the air inlet pipe located on the back
of the stove and using an adapter through your floor or wall. The outside end of this pipe should be
covered in some manner (i.e. with a screen) to keep it clear of foreign matter. Be sure to keep it above
the snowdrift line and clear of leaves and other debris.
NOTE: THIS UNIT IS NOT UL TESTED OR RATED. INSTALL TAKING ALL PRECAUTIONS AND
TEST YOUR CLEARANCE TO COMBUSTIBLES AFTER INSTALL TO MAKE SURE SURFACES
AROUND THE STOVE DO NOT GET HOT!!!
BEFORE INSTALLATION OF YOUR APPLIANCE
FIRE.

Advertisement

Table of Contents
loading

Related Products for 509 Fabrication 5095-1

Table of Contents