Exmark ECSKA21 Setup Instructions

Exmark ECSKA21 Setup Instructions

Advertisement

Quick Links

This product contains a chemical or chemicals known to the State of California to
The engine exhaust from this product contains chemicals known to the State of California

Loose Parts

Use the chart below to verify that all parts have been shipped. Part numbers not shown are available on the dealer
extranet.
Dealer Pack
Part #
614249
Literature Pack
Manual, Operator's
Manual, Engine Operator's – Honda
Manual, Engine Operator's – Kawasaki
© 2012—Exmark Mfg. Co., Inc.
P.O. Box 808
Beatrice, NE 68310
Proposition 65 Warning
cause cancer, birth defects, or reproductive harm.
to cause cancer, birth defects, or other reproductive harm.
Description
Wire Ties
Warranty Registration Reminder
WARNING
CALIFORNIA
Qty.
2
COMMERCIAL 21
Setup Instructions
For Serial Nos. 313,000,000 & Higher
Use
Positioning the cables on the handle
bar.
Fill out the online warranty registration
form.
All Rights Reserved *4501-531* A
Part No. 4501-531 Rev. A
Printed in the USA

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ECSKA21 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Exmark ECSKA21

  • Page 1 Literature Pack Manual, Operator's Manual, Engine Operator's – Honda Manual, Engine Operator's – Kawasaki © 2012—Exmark Mfg. Co., Inc. All Rights Reserved *4501-531* A Part No. 4501-531 Rev. A P.O. Box 808 Printed in the USA Beatrice, NE 68310...
  • Page 2 Removing the Unit from the Box Remove the unit from the box. Installing the Handle 1. Remove the mounting hardware from the mower housing and handle bracket. 2. Lift the handle brackets upward and mount the handle to the outside of the mower housing as shown in Figure 1.
  • Page 3 Figure 4 Figure 3 1. Starter rope 2. Rope guide 1. Blade control bail 2. Handle 3. Drive bail 4. Cable end Installing the Fuel Tank (If Shipped 5. Mounting hardware Loose): 6. Drive cable assembly 7. Wire tie 1. Remove the screw(s) from the underside of the fuel 8.
  • Page 4 Filling the crankcase with oil For units with Honda Engines: The engine crankcase can hold 22 ounces (0.65 liters) of oil. Exmark 4-Cycle Premium Engine Oil is recommended. Refer to the Engine Owner’s Manual for an acceptable alternative. Do Not overfill.
  • Page 5 Attaching the Product Banner If provided, tie wrap the product banner to the handle as shown in Figure 9. Figure 9 1. Tie wrap 2. Product banner Check the Cable Adjustments Follow the procedures in the manuals to ensure the self-propel drive and BBC cables have been adjusted properly.

Table of Contents