Check List - Dometic miniCool Instructions For Use Manual

All manuals and user guides at all-guides.com
5.11

Check List

Problem: No cooling (the aggregate at the back of the device is cold).
Possible Cause
a.) The thermostat is set to “0”.
b.) The device plug is not
plugged in.
c.) No voltage in socket.
d.) Defective electronics or
sensor feelers.
e.) Defective heating cartridge.
f.) The device is in its defrosting
phase.
Problem: No cooling (the aggregate is warm).
Possible Cause
a.) The device is not level.
b.) The device was only
switched on a short while ago.
c.) Defective cooling aggregate.
Problem: Poor Cooling Performance.
Possible Cause
a.) The cooling aggregate is not
sufficiently ventilated.
b.) The device is exposed to
direct sunlight.
c.) The fridge door does not
close tightly.
d.) Light permanently on when
door closed.
e.) The fridge was stocked a
short while ago.
Problem: Frost formation in fridge.
Possible Cause
a.) The fridge door does not
close tightly.
Self Help
a.) Set temperature control to
middle position.
b.) Plug in device plug.
c.) Check building fuse.
f.) See operating instruction
5.3
Self Help
a.) Level the device using a
spirit level.
b.) Switch on the device and
let it run for 5-6 hours.
Self Help
a.) Check that the ventilation
grids are not covered. Check
that device has been installed
properly (installation instruction
4.5).
b.) Follow installation
instruction 4.5.
c.) Check installation in line
4.5.
e.) Check fridge after 5-6
hours for proper cooling
function.
Self Help
a.) Check installation is in line
with 4.5.
13
Authorised Service
d.) Install new
electronics or sensor.
e.) Install new heating
cartridge.
Authorised Service
c.) Check whether
repair is feasible. If not,
exchange device.
Authorised Service
c.) Is door magnet
there? Install new door,
if required.
d.) Replace lighting
sensor. Install new door,
if required.
Authorised Service
a.) Is door magnet
there?
Install new door.