Advertisement
6
Place Lead Shield on Arm. This will require the
removal of the six bolts.
A. Place the shield on a level surface with
the Arm on top of the shield.
B. Then, place the bolt through the holes.
7
Place Inner Rod into Arm. For the assembly
process start with loosen the allen set screw.Once
the Arm is placed on Tighten the Allen set screw.
Tighten Allen Set Screw to secure the arm to the
Inner Rod.
8
Finally Adjust height to desired specifications.
A. Unscrewing the Hand Tight Bolt
B. Adjust height to desired specifications.
C. Slide push pin into set of holes above
desired height.
D. Loosen the Hand Tight Bolt, again and
slowly lower the Inner Rod to where the
point of where the Push Pin is holding all
the weight of the Rod.
E. Again, tighten the hand tight bolt.
Mobile Lead Porta-Shield,
LB-MB2424, LB-MB2436, LB-MB2448
a. The bolt should consist of the
Face of Bolt, Washer, Shield,
Arm, Second Washer, and Lock
Nut
b. Have the face of the bolt on the
floor, while the lock nut and
washer are on the top of the arm
3
Advertisement
