Nexa PX-700IV Setup
  1. Manuals
  2. Brands
  3. Nexa Manuals
  4. Printer
  5. PX-700IV
  6. Setup

Nexa PX-700IV Setup

Hide thumbs Also See for PX-700IV:
1
2

Advertisement

Table of Contents

NEXA PX-700IV PRINTER

ETHERNET SETUP

When set to a fixed IP address the IP address settings will appear on the test print.
However by default the printer is set to get an auto assigned IP address. This does not
appear on the test print as takes 5-10 seconds after being switched on to be assigned.
Instead you see the following
While it says to press a function key you actually press and hold the feed to access the
ethernet information via the VMSM Selection

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the PX-700IV and is the answer not in the manual?

Questions and answers

Related Manuals for Nexa PX-700IV

Summary of Contents for Nexa PX-700IV

  • Page 1 NEXA PX-700IV PRINTER ETHERNET SETUP When set to a fixed IP address the IP address settings will appear on the test print. However by default the printer is set to get an auto assigned IP address. This does not appear on the test print as takes 5-10 seconds after being switched on to be assigned.
  • Page 2 Here are the steps 1. Turn off power on printer 2. Hold feed button 3. Turn on power 4. Release button and wait for test print to finish. 5. Press and hold feed button till VMSM Selection prints 6. Press and release once 7.

Table of Contents