Ar-32P Controls & Connections - Elation AR-32 User Manual

The AR-32 is capable of holding up to 32 shows in memory, limited by a memory size of 128 Mb. Shows are
configured using the AR-32 System Control Software. When operating the AR-32 in Manual mode, the 32
shows are mapped to the controllers [SHOW] buttons. Table 2 explains the show mappings used by the AR-32.
Button [SHOW1] [SHOW2] [SHOW3] [SHOW4] [SHOW5] [SHOW6] [SHOW7] [SHOW8]
[PAGE1] Show1
[PAGE2] Show9
[PAGE3] Show17
[PAGE4] Show25
6.2 AR-32P Controls & Connections
The AR-32P DMX Interface (Figure 9) has the following controls and connections described in Table 3.
1
2
3
4
5
6
No.
1 [POWER]
2 FUSE
3 Power IN
4 DMX IN
5 DMX OUT
6 TO AR-32C
Show2 Show3
Show10 Show11
Show18 Show19
Show26 Show27
F R O N T
Name
[POWER] switch turns the system on and off.
FUSE connection allows user to replace the power supply fuse.
Power IN cable provides AC power connection to the system.
DMX IN provides data connection from DMX sources via 3-pin
XLR connector.
DMX OUT provides data connection to DMX fixtures via 3-pin
XLR connector.
TO AR-32C provides data connection to AR-32C controller via RJ-
45 connector.
www.elationlighting.com
Table 2
Show4 Show5
Show12 Show13
Show20 Show21
Show28 Show29
B A C K
Figure 9
Table 3
Description
Show6 Show7
Show14 Show15
Show22 Show23
Show30 Show31
Show8
Show16
Show24
Show32
6
17