Safety Instruction - GCE proFIT SLM Instructions For Use Manual

8. SAFETY INSTRUCTION

8.1. PRECAUTIONS OF OPERATION AND USING
• Fix the machine position and install the machine properly before starting to use and check.
• Make sure that the switch is in "middle" position before inserting the plug into power socket.
• Keep these operating and safety instructions with you when operating the machine.
EN
• Do not carry the machine while flame is on.
• Prevent metal pieces or burr fall if the machine is working above the floor level.
• Be very careful when transporting the machine to another place.
8.2. PROTECTION PRECAUTIONS REGARDING ELECTRICITY SYSTEM
• Check the network voltage power before starting using. Maximal voltage variations should
be ±10% of the specified voltage. Machine shall not be used with different voltage.
Use cutting machine only with the specified voltage.
• Earthen the cable of your machine.
• Send the machine to the Authorized Service or the dealer you bought the machine from
when following situation happen:
• Broken or worn cables.
• If water drips from your machine or if water leaks into the machine.
• If you see there is something wrong about operation in spite of proper operation.
• If the machine breaks down.
• Complicated fault requiring repair.
• Periodically check the electricity system.
8.3. MAINTENANCE AND CONTROL PRECAUTIONS
• Assign a competent authorized person for maintenance and control.
• Remove the plug from the socket before machine body opening and machine repair.
• Apply periodical maintenance to the machine.
Only use the proper cutting torch and nozzles. Respect the fuel gas type when choosing torch
and nozzle.
9. SAFETY SUITS
• Safety suits (gloves, protective glasses with proper light filter, helmet, and protective shoes)
shall be used by operator during cutting operation.
• Wet clothes can lead to electricity accidents.
• Keep the clothes free of oil and grease to avoid reaction with oxygen
12/136