Troubleshooting - GCE proFIT SLM Instructions For Use Manual

6. TROUBLE SHOOTING
Failure
Drive
wheel does not
turn
Ragged
Cutting
Surface
(see also adjust-
ment recommen-
dation below)
7. STORAGE, CARRYING AND TRANSPORTATION
7.1. PACKING
GCE proFIT SLM is surrounded by preser-
®
vations all around the box. Cutting machine
body is in the box separated from the ac-
cessories; the box is divided into two parts.
7.2. STORAGE
If the cutting machine is not going to be
used for a long time, keep the electric
components, torch and nozzles in the box to
protect them from dust, humidity and other
impurities.
7.3. CARRYING
Keep the product in the box to prevent
failures arising from shocks and vibrations during carrying.
7.4. TRANSPORTATION
Keep the product properly in its box to prevent it from damages during transportation. Storage,
carrying and transportation
Cause
Cable connections are loose
Defective commutator
Failure of the main electric cable
Defective motor
A ragged surface
Unfitting rail
Rotating speed of the motor is
wrong
External vibration
Wrong cutting parameters
adjustments
Abnormal delays in propulsion
gear component
Distortion of the torch
11/136
Repair
Check the solder of the cables.
Check the cable connection.
Check the commutator with a
test device.
Check the main electric cable
with a test device.
Check it with a test device.
Check if the motor spindle
rotates.
Make sure that the surface to be
cut is smooth enough for the
rail to fit
Check or replace the control
units.
Stop vibrations
Check the speed of cutting with
the ruler.
Repair it or get it repaired.
Replace it.
Fig 9. An example of packing
EN