Related Manuals for Oceanled WiFi DMX TOUCH
Summary of Contents for Oceanled WiFi DMX TOUCH
- Page 1 2021 INSTALLATION & OPERATION MANUAL Wi-Fi DMX TOUCH PANEL CONTROLLER KITS L I G H T. Y E A R S A H E A D . WWW.OCEANLED.COM OceanLED MANUAL / CONTOLLERS / WiFi DMX TOUCH / REVISION 0.1...
- Page 2 CONTROLLER KITs. 2021 INSTALL & OPERATION MANUAL Preface READ AND FOLLOW ALL INSTRUCTIONS IN THIS MANUAL WARNINGS Before installing your DMX Controller, read and follow all warning notices and instructions which are included. Failure to follow safety warnings and instructions can result in property damage, severe injury or even death.
-
Page 3: Table Of Contents
Attention Installer: This manual contains important information about the installation, operation and safe use of this product. This information should be given to the owner and/ or operator of this equipment. WARRANTY COVERAGE Please refer to www.oceanled.com/downloads for full warranty statement. -
Page 4: Overview
The chosen location requires access to mains power, space for the routing of the DMX cable to the driver boxes, and also an Ethernet connection to a Wi-Fi router / LAN Wi-Fi for the Wi-Fi controller if the Wi-Fi function is required. For DC power installations please contact OceanLED for advice 1.3 SPECIFICATIONS •... -
Page 5: Installation
CONTROLLER KITs. 2021 INSTALL & OPERATION MANUAL Installation 2.1 CONNECT THE WIRES (EXPLORE E6 & E7) 1. Connect the control cable to the green connector (as below) • DMX Ground = Black • DMX - = Brown • DMX + = Yellow •... - Page 6 CONTROLLER KITs. 2021 INSTALL & OPERATION MANUAL 2.3 MOUNT IN A DRY LOCATION 1. Plug the green connector block into the rear of the DMX Wi-Fi Touch Panel Controller. 2. For Wi-Fi plug the local ethernet cable into the rear of the DMX Wi-Fi touch panel controller (Ensure the correct RJ45 port is used): DMX/Power Connector...
- Page 7 2021 INSTALL & OPERATION MANUAL 2.4 FINALISE YOUR INSTALLATION (EXPLORE E6 & E7) Always test the system BEFORE the boat goes back into the water. Typical OceanLED light installs require the boat to be hauled out of the water to replace light units.
- Page 8 2021 INSTALL & OPERATION MANUAL 2.5 FINALISE YOUR INSTALLATION (PRO SERIES) Always test the system BEFORE the boat goes back into the water. Typical OceanLED light installs require the boat to be hauled out of the water to replace light units.
-
Page 9: Operation
CONTROLLER KITs. 2021 INSTALL & OPERATION MANUAL Operation 3.1 POWER / SCENE SELECTION 1. Power on the unit by touching the top centre button. 2. Select the required scene by using the buttons under the ‘Select Area’ buttons below the display to select the required area and select the scene by touching the left / right arrows either side of the display. - Page 10 CONTROLLER KITs. 2021 INSTALL & OPERATION MANUAL 3.2 PRE-PROGRAMMED SCENES – EXPLORE Explore Dual White / Blue Scene Number Function White White Solid Blue Blue Colours Blue/White Blue 50% White 50% Mix White Strb White Strobe Blue Strb Blue Strobe Dynamic Modes B/W Strb...
- Page 11 CONTROLLER KITs. 2021 INSTALL & OPERATION MANUAL Explore / Pro Series Colours Scene Name Function Orange Orange Yellow Yellow Green Green Blue Blue Indigo Indigo Violet Violet White White Solid Colours Red 2 Red Shade - 2 Red 3 Red Shade - 3 Green 2 Green Shade - 2 Green 3...
-
Page 12: Troubleshooting
CONTROLLER KITs. 2021 INSTALL & OPERATION MANUAL Troubleshooting Wi-Fi DMX Touch Panel Controller Problem Check Cause DMX controller does not Check Power to No Power Connect Power power on Controller is on Power OK Check Connections Check Connections to Connected incorrectly Correct Connections controller faceplate Connected OK... -
Page 13: Warranty
KITs. 2021 INSTALL & OPERATION MANUAL Warranty Please remove this page and keep for your files For technical assistance: Europe: service@oceanled.com The Americas: warranty@oceanledusa.com Warranty Serial Code(s): Ocean LED Marine LTD Ocean LED USA LLC © 2021 Ocean LED Marine LTD...