Teledyne Lecroy TF-HDMI-3.3V Instructions

TF-HDMI-3.3V Pull-up Termination Adapter
HDMI compliance testing requires signals to be terminated with a 50 Ω pull-up to 3.3 V when
performing direct cable measurements.
The TF-HDMI-3.3V provides such a termination while transmitting the signal to the oscilloscope
input. It is designed for full HDMI bandwidth so that the signal is not degraded.
TF-HDMI-3.3V is compatible with all oscilloscopes with the ProLink input and MAUI™ firmware
version 5.6.x.x or higher.

Specifications

Interface
Input Connector Type (SIG, TERM)
Output Connector Type
Input Coupling
Input Impedance
Output Source Impedance
Non-destruct Input Range
DC Gain into 50 Ω
AC Gain
Input Return Loss
S22
Rise Time (10-90%)
Rise Time (20-80%)
Overshoot
Schematic
933353-00 Rev A
ProLink
SMA (f)
BMA (m), ProLink
50 Ω - DC
50 Ω
50 Ω
1.5 Vmin to 3.5 Vmax
0.167 ±1.5%
-15.5 dB ±0.5 dB @ 0 Hz to 2 GHz
-15.5 dB ±1 dB @ 2 GHz to 10 GHz
> 20 dB @ 0 Hz to 2 GHz
> 15 dB @ 2 GHz to 8 GHz
> 10 dB @ 8 GHz to 10 GHz
> 6 dB
< 35 ps
22 ps typical (measured with a fast edge)
< 5% (20 ps risetime input)
Instructions
Over

1