Advertisement
Cruise Control
Activate
To activate, pull the control stalk toward you to the ON position.
Set or Change Speed
At your desired speed, press the SET button on the end of the stalk.
The set speed along with the respective indicator light is shown in the
driver information display.
There are several ways to change your speed:
•
Accelerate or decelerate, then press the SET button again.
•
Push the stalk up or down to increase/decrease speed in 1mph increments.
•
Hold the stalk up or down for continuous increase/decrease speed; release when desired speed is reached.
Cancel/Resume
To cancel and resume cruise control:
•
To cancel, press the brake pedal or push the stalk briefly away from you one detent to the CANCEL position.
•
The indicator light will go off in the driver information display.
•
To resume, pull the stalk toward you; you will return to your set speed.
Your most recently set speed remains in memory until you turn cruise control or the ignition off.
Adaptive Cruise Assist
For vehicles with adaptive cruise assist, the system is a combination of speed and distance regulation and helps maintain
a distance from the vehicle driving directly ahead. Adaptive cruise assist can brake and accelerate as necessary to help
maintain the selected distance.
•
To activate, set, cancel or resume cruising speed, follow the same instructions as standard cruise control.
•
When a vehicle is equipped with adaptive cruise assist, pushing the stalk up or down will increase/decrease speed in
2.5 mph increments.
The greater the speed, the greater the distance that is needed. To change the set distance:
•
Tap the DISTANCE rocker switch to display the current set distance.
•
To increase or decrease the distance setting, tap the switch again toward
Lane Departure Warning
Within the limits of the system, the active lane departure warning* gives an alert before the vehicle drives over the lane
markings. The warning takes place visually and through the steering wheel and optionally via a vibration. You can always
intervene. The system is designed for highway and major roads. Press the
lane guidance on or off. Lane guidance is on, but not ready to provide warnings when the indicator light is white
conditions may deactivate lane guidance, such as no lane lines, a lane too narrow or wide, etc.
Driver Assist Settings
To choose driver assist settings, in the touch display, select Vehicle
Driver assist. Depending on vehicle equipment, features may include:
•
Speed warning.
•
Adaptive cruise assist.
•
Distance warning.
•
Audi pre sense.
•
Side assist.
Park Assist
Park assist* automatically steers the car into parallel or perpendicular parking spaces using ultrasonic sensors, while the
driver works the gear shift, accelerates, brakes, and monitors the vehicles surroundings. To turn on, press the
located below the upper touch display. The LED will turn on and the park assist display will appear in the Infotainment
system. To search for parking spaces on the driver's side, activate the left turn signal. To switch off, press the Park Assist
button again.
*Driver assistance features are not substitutes for attentive driving. See Owner's Manual for further details, and important limitations.
Warnings: Driver Assistance
See Driver Assistance in your Owner's Manual for more detailed information and for important safety warnings.
Driver Assistance Features
or
.
button on the turn signal lever to switch
. Some
button
Advertisement
