Snuza Pico 2 Quick Start Manual

Hide thumbs Also See for Pico 2:

Pico 2 Quick Start Guide

1. Download the Snuza Connect app

2. Follow the prompts to register

3. Activate your account via the e-mail link

4. Once activated, add the Pico to your account

5. You can find the serial number on the side of the Pico 2 by lifting its top lever

1. Attach the micro USB power cord to the charging cradle base. A red light will

appear on the charging cradle base to indicate it has power.

2. Open the charging cradle lid and place your Pico 2 in the correct position

3. Close the lid

4. The battery light on the Pico 2 will flash while charging and turn solid green

when fully charged

1. Lift Pico 2's top lever to release clip (fig.1)

2. Fold over the top edge of the diaper and place the Pico 2 on your baby's

diaper sliding your fingers between the clip and your baby's skin (fig.2)

3. Ensure that the clip is properly closed once placed and that no skin is

pinched in clip (fig.3)

Snuza Connect App Setup:

Snuza Pico 2 Device Setup:

Charge your Snuza Pico 2

Attach your Snuza Pico 2:

SLIDE ON

PRESS DOWN

NAPPY

SKIN

Table of Contents

Do you have a question about the Pico 2 and is the answer not in the manual?

Page 1 3. Activate your account via the e-mail link 4. Once activated, add the Pico to your account 5. You can find the serial number on the side of the Pico 2 by lifting its top lever Snuza Pico 2 Device Setup: Charge your Snuza Pico 2 1.
Page 2 1. Switch the Pico 2 on by briefly pressing the power button 2. All indicator lights will flash and a start-up tone will be heard 3. Alternatively, switch the Pico 2 on by pressing the power button in the app. The start-up tone will be silent if controlled via the app.