Summary of Contents for Leica RINEX AgChem SP AutoSPRAY B
- Page 1 AgChem SP AutoSPRAY cable B (Part No. 1-2817) Installation Manual Part Number: 1-1267 Revision: Issue Date: October 2008...
- Page 2 INTRODUCTION The AgChem Self Propelled AutoSPRAY Cable B, optional cable, (Part No: 1-2817) is designed to suit the following installations: Compatible Vehicles Rogator 1254 Rogator 1264 Rogator 1274 The cable will detect the status of the Master Switch and control the seventh section of the boom if installed, but only if Cable A (Part No 1-2816) is already installed.
- Page 3 INSTALLATION A schematic of the cable and its relevant cabling to the installation is shown in Figure 3. Figure 3: Schematic layout Of typical AutoSPRAY installation It is recommended that all electrical wiring should be installed by a qualified auto-electrician. Incorrect wiring may damage the AutoSPRAY controller and/ or the spray rate controller.
- Page 4 Step Instruction Locate the wiring panel inside the cabin with the multi- coloured wiring harness (Connectors-B) as shown in Figure Disconnect the mating connectors (B) as shown in Figure 5. Plug the supplied optional cable in-line between the two mating connectors from Step 2. Connect the wires labeled "MASTER"...