Advertisement
Step
1.
Locate the wiring panel inside the cabin with the multi-
coloured wiring harness (Connectors-B) as shown in Figure
5.
2.
Disconnect the mating connectors (B) as shown in Figure 5.
3.
Plug the supplied optional cable in-line between the two
mating connectors from Step 2.
4.
Connect the wires labeled "MASTER" and "SECTION 7" to the
supplied cable.
5.
Confirm that the spray controller and boom section switches
function correctly.
Consult the AutoSPRAY controller installation manual to
setup and calibrate the AutoSPRAY system.
Figure 4
1-1267 Rev A
Instruction
AgChem SP AutoSPRAY Cable B Installation
B
A
Figure 5
Page 3
Advertisement
