Nienkamper CERN BOOKCASE CREDENZA Installation Manual

CERN BOOKCASE CREDENZA
INSTALLATION GUIDE
TOOLS REQUIRED:
4mm Hex Key
5mm Hex Key
1/8" Hex Key
#2 Phillips Screwdriver / Bit
#3 Phillips Screwdriver/ Bit
Clamp
Mallet
Hammer
On a protective surface, lay gables and top with back edge on floor. Screw mini fix pin into gables. Insert wood dowels into remaining
holes. Install mini fix cam into top with phillips drive facing out and arrow facing though hole. Align all holes in top with dowels / pins
and gently push together. Be sure to align lighting cable with groove in gable so damage does not occur when tightening. With a #3
phillips screwdriver, turn mini fix cam to lock assembly. Repeat both sides.
Install all shelf mounting blocks by screwing 1/4"-20 x 1 5/8" socket head cap screw through block and into pre-installed inserts in gable.
Repeat step for all mounting blocks.
Customer Support: 1.800.668.9318
Email: mail@nienkamper.com
Web: www.nienkamper.com
HARDWARE:
1/4"-20 x 7/8"
Joiner Bolt
Mini-Fix
Screw,
Cam &
1/4"-20 x 1
5/8" Socket
Head Screw
1/4"-20 x
1/4"-20 x 1
9/16" Joiner 1/4" Joiner
1/4"-20 x 7/8" Modeze
Set Screw Screw
Shelf
Mounting
Block
mini fix
cam
top
Page 1 of 4
SUGGESTED MINIMUM CREW:
APPROXIMATE INSTALL TIME:
1/4"-20
Joiner nut
#6 x 5/8"
Pan Head
Wood Screw
Wire
Cover
mini fix screw
dowel
gable
light power cable
2-3
2 Hrs
Wood Dowel
#6 x 5/8"
Pan Head
Wood Screw
Wire
Manager