Download Print this page
Summer 27680A Instruction Manual

Summer 27680A Instruction Manual

Custom fit walk-thru gate

Advertisement

Quick Links

Regularly check hinge knobs to make sure the gate is securely in place.
Do not use the gate if any components are damaged or missing.
Wipe surface with a damp cloth or sponge, using mild detergent and
cold water.
To order a replacement hardware kit (
at the address/telephone number below.
We're here to help! If you have questions or need assistance,
please contact our Consumer Relations Team at
1-401-671-6551 or www.summerinfant.com/contact
1275 Park East Drive
Woonsocket, RI 02895
1-401-671-6551
© 2019 Summer Infant (USA), Inc.
), contact us
INSTRUC TION MANUAL
Colors and styles may vary.
1/19
Please read the following instructions carefully.
Keep this instruction manual and save for future reference.
For technical support, contact us at
or
Tools required: Phillips-head screwdriver (not included).
For use with children from 6 - 24 months.
Keep small parts away from children.
Adult assembly required.
Fits openings from 65" - 141" wide.

Advertisement

loading
Need help?

Need help?

Do you have a question about the 27680A and is the answer not in the manual?

Questions and answers

Summary of Contents for Summer 27680A

  • Page 1 We’re here to help! If you have questions or need assistance, please contact our Consumer Relations Team at 1-401-671-6551 or www.summerinfant.com/contact 1275 Park East Drive Woonsocket, RI 02895 1-401-671-6551 Colors and styles may vary. © 2019 Summer Infant (USA), Inc. 1/19...
  • Page 2 WARNING Children have died or been seriously injured when gates are not securely installed. • ALWAYS install and use gate as directed using all required parts. Remove the two screws from • Install according to manufacturer’s instructions. the Upper Gate Hinge on one end panel •...
  • Page 3 For openings 65" - 87" (165 cm - 221 cm), refer to “TWO PANEL SETUP” For openings 65" – 87" (165 cm - 221 cm) section, and use Template for mounting 2 Panel Gate. Unscrew upper knob on Cut out Wall Template (for mounting “3” Panel Hinge between end panel and Gate).
  • Page 4 Unfold gate panels and attach 2 feet as shown in Figures D and E. Repeat the mounting procedure in Step 6 to connect end panel to wall. Turn expansion handle(s) counter-clockwise until tight (Figure J). (Opposite of Step 8.) Once both panels are securely mounted to each wall, turn the 4 hinge knobs clockwise Attach one end of gate to Upper...