Experimental Start-Up Of Device (Without Alloy) - Polaris Easy Cast Instruction Manual

Experimental Operation (without Alloy)
Before starting the melting operations, check to see if the product is in proper
functioning order by following these steps:
1.Place the 30 mm ring on the smallest ring base.
2.Use the special fork to place the ring and its base on the arm of the product.
3.Place the ceramic crucible in its proper place on the rotating arm.
4.Use the switch to turn on the system.
5.Place the arm on the machining center until the alarm sounds and the indicator
light is turned on.
6.Use Switch 4 to lift the coil.
7.Use Switch 6 to start the melting process.
8.Close the top lid of the machine.
9. Operate Switch 8 to start the casting operation.
10.Allow the machine to rotate for 10 to 20 seconds.
11.Operate Switch 10 to stop the machine.
12.Wait 30 seconds until the machine automatically unlocks the lid so that you
can open it.
13.Open the top lid.
22