Subscribe to Our Youtube Channel
Related Manuals for Franke BBR Series
Summary of Contents for Franke BBR Series
- Page 1 BBR - Bottled Beverage Refrigerator Installation & Operating Manual [P/N 19001150]...
- Page 2 Important READ FIRST General: 1. This Installation & Operating Manual contains important instructions and safety information on the Bottled Beverage Refrigerator (BBR). Read and understand the contents of this manual before attempting to: Uncrate, Install, Operate, Clean or perform Routine Maintenance. 2.
- Page 3 Section 8 of this manual. 2. For any other service or performance problem not covered or corrected by Basic Troubleshooting procedures call: Franke Technical Support at (800) 537-2653 (press 5) in North America. 3. All service or repair work must be done by a licensed professional trained and authorized to perform service on Franke products.
-
Page 4: Table Of Contents
Important CAUTIONS & WARNINGS Page 2 Equipment Diagram: Key Components Page 5 1 Installation Page 6 [For More Installation Detail – See Doc. 19001089] 2 Shelf Component System Page 11 [For Shelf Setup Instructions – See Doc. 19001091] 3 Glass Door Removal & Replacement Page 12 4 Controls &... -
Page 5: Installation
Franke BBR Key Components [Model BBR-45 Shown] Condenser Coil Access Panel Power Cord Exit Hole Main Power Switch Cord Exit Operating Temperature Display Rollback Sliding Doors Rear Upper Shelf Supports 1 Installation BBR Operating Manual Page 5... - Page 6 1 Uncrate the Unit This unit will arrive crated in a skid-mounted carton. Caution! The shipping container may have staples, nails, banding under tension and possible wood splinters, which can cause injuries. Wear gloves and eye protection to reduce the risk of injury when uncrating.
- Page 7 § Wipe down, sanitize and dry the refrigerator interior. § Wipe down, sanitize and dry individual shelf components if pre- installed. WARNING – Wall preparation must be done by qualified carpenters and/or equipment installers capable of evaluating wall construction and securely wall mounting a heavy refrigerated case. Wall anchor failure could cause serious injuries or even death.
- Page 8 unit top and another on the sloped left side service access panel. Choose the closest one and pull out enough power cord to reach the wall outlet or chase-mounted outlet. 7 Wall Structure & Surface Preparations § Standard Mounting - The mounting wall must be prepared according to the rough-in drawings shown in Figure 2 at right,...
- Page 9 engage the full width of the refrigerator case top-rear frame/flange. § Locate center point of desired case-mounting position on wall surface. Measure up 82” from floor for BBR-36” Model or 80” for BBR-45” Model, which will provide a BBR unit bottom height or clearance of 57”.
- Page 10 If the unit is delivered with the shelf system in place, it will be set up in the basic McDonald’s Display Configuration and the shelf system components shipped in a separate cardboard carton. See Shelf Setup Instructions [Franke Doc. No. 19001091], which is packed with those shelf components. NOTE: Black coated wire shelf components shown.
-
Page 11: Glass Door Removal & Replacement
3 Glass Door Removal & Replacement The sliding glass doors on the BBR refrigerated case can be removed to lighten the case during wall mounting, to speed and simplify shelf assembly and aid in track cleaning. 1 To Remove Sliding Glass Doors - §... - Page 12 To turn ON the BBR Case: § Verify power cord is plugged in to a working 120-volt/60-Hz power outlet. § Turn ON main power switch located upper-left on case front, next to the temperature display. Red switch light comes on when power is ON. §...
-
Page 13: Loading The Refrigerator
5 Loading & Restocking The Refrigerator The BBR Case can be loaded or restocked at any time, if the unit has reached the target refrigerated product holding temperature of 34° to 40° To make product loading easier, door- OPEN stops have been added to both sliding auto-close doors. -
Page 14: Store-Closing Procedure
General Product Loading Tips: § DO NOT load warm product directly into the BBR Case. Pre-chill product in walk-in before transferring to the display case. § DO NOT over-fill the BBR Case. All refrigeration requires good air circulation to maintain uniform temperatures. -
Page 15: Preventative Maintenance
§ Clean, sanitize and dry that shelf component and any others soiled by the leak. § At end of day, initiate full (Monthly) case cleaning, per instructions in Section 6, beginning page 17. 7 Preventive Maintenance WARNING! Verify refrigerator is disconnected from the power source before attempting any preventive maintenance. - Page 16 § Place all shelf components in the sink then wash, sanitize and wipe dry or allow to air dry. § Remove both glass doors. [Slide back, lift up and angle out door bottom, releasing upper door spring catch in top tract.] Clean the glass on both sides.
-
Page 17: Basic Troubleshooting
If necessary, adjust BBR factory preset operating temperature. See pages 13-14 for procedure. If these steps do not fix problem, call Franke at (800) 537-2653 and press 5 for Technical Services. Condenser Coil is dirty or Use a vacuum cleaner or soft brush to clean clogged with debris. - Page 18 Mounting System Metal hanging strip [provided]; fastners [by others] Franke Foodservice Systems (“Franke”) warrants new equipment manufactured in Franke’s own facilities and installed in the United States and Canada to be free of defects due to poor materials or workmanship for the period of time listed below (following the date of original...
- Page 19 Exclusions. Certain Franke parts that are expendable by nature and that need to be replaced frequently may not be covered. Franke is not liable under these warranties for repairs or damages due to improper operation, attempted repairs or installation by unauthorized persons, alterations, poor water quality, abuse, fire, flood or acts of God.
- Page 20 In these situations, Franke Technical Support will work directly with the customer to find mutually acceptable options. Franke reserves the right to use service agents outside of the stated Service Network.
- Page 21 Franke Foodservice Systems 305 Tech Park Drive LaVergne, TN 37086 800-537-2653 www.frankefs.com [P/N 19001150] BBR Operating Manual (Revised 4/08) BBR Operating Manual Page 21...
Need help?
Do you have a question about the BBR Series and is the answer not in the manual?
Questions and answers