Table of Contents
Advertisement
Available languages
Available languages
EN
Description of main parts
1. Blade
2. Hand guard
Operation
[A] CAUTION:
- Be careful not to accidentally contact a metal fence or other hard objects while trimming. The blade will break and may cause serious injury.
- Overreaching with a hedge trimmer, particularly from a ladder, is extremely dangerous. Do not work from anything wobbly or unfirm.
- Do not attempt to cut branches thicker than 10 mm diameter with this trimmer. These should first be cut with shears down to the hedge trimming level.
CAUTION:
- Do not cut off dead trees or similar hard objects. Failure to do so may damage the tool.
[B] Hold the trimmer with both hands, pull the switch trigger and then move it in front of your body.
[C] As a basic operation, tilt the blades (3) towards the trimming direction (1) and move it calmly and slowly at the speed rated of 3 - 4 seconds per meter
above the hedge surface to be trimmed (3).
[D] To cut a hedge top evenly, it helps to tie a string (1) at the desired hedge height and to trim along it, using it as a reference line. In other circumstances,
in order to cut a hedge side evenly, it helps to cut from the bottom upwards. Additionally, in order trim boxwood or rhododendron from the base to
ward to the top for a nice appearance and good job.
5
3. Handle, front
4. Handle, rear
A
D
WWW.BORMANNTOOLS.COM
5. Switch Trigger (ON/OFF)
B
C
F
Advertisement
Table of Contents
