Setup; Assembling The Handle - Toro 20944 Operator's Manual

Setup

Important:
Remove and discard the protective
plastic sheet that covers the engine and any other
plastic or wrapping on the machine.
1

Assembling the Handle

Parts needed for this procedure:
2 Lower handle
4 Short bolt
4 Flat washer
4 Split washer
4 Nut
1 Upper handle
2 Handle knob
2 Curved washer
2 Long bolt
Procedure
1. Attach the lower handle to the mower housing
with the 4 bolts, 4 flat washers, 4 split washers,
and 4 nuts (Figure
1. Bolt (4)
2. Flat washer (4)
2. Attach the upper handle to the lower handle
using 2 handle knobs, 2 curved washers, and
2 bolts. Tighten the handle knobs securely by
hand (Figure 4).
3).
Figure 3
3. Split washer (4)
4. Nut (4)
1. Handle knob (2)
2. Curved washer (2)
3. Bolt (2)
3. Insert the cables into the cable clamp and attach
the cable clip to the handle as shown in
1. Cable clip
g188335
4
Figure 4
4. Upper handle
5. Lower handle
Figure 5
g188346
Figure 5.
g189081