Timer Function - DeLonghi TRD40615ECA Instructions For Use Manual

will activate the Antifreeze function. The display will
show the symbol, in this way the appliance will turn
on automatically, at the max power, only if the room
temperature falls below 5°C (41°F), to prevent freezing
conditions. If you wish to go back to the Heating function,
press the "+" button once.
Please note: in this function the power level settings
are not able to be adjusted, unit will run at MAX.
Eco function
When this function is active the appliance automatically
sets the most appropriate power level to guarantee
optimum comfort while reducing energy consumption.
To activate this function press the "ECO" (H) button. The
display will show symbol.
If the selected temperature is much higher then the actual
room temperature, the appliance will start automatically
and rapidly to heat the room.
The appliance will automatically select the most convenient
power level (MAX-MED-MIN-OFF).
If MAX power level has been selected using the
button, the appliance will cycle between: MAX-MED-MIN-
OFF. If MED power level has been selected, the appliance
will cycle between: MED-MIN-OFF.
If MIN power level has been selected, the appliance will
cycle between: MIN-OFF.
Working indicator
The symbol indicates the heating status by means of
its colors.
RED: the unit is heating at the maximum power.
YELLOW: the unit is heating at the medium power.
GREEN: the unit is heating at the minimum power.
absent: the unit is not heating.
Brightness of the display
The appliance allows two different brightness settings
for the display. The highest is active when any key button
is pressed. After a few seconds of keyboard inactivity, the
brightness will decrease to the operating brightness level.
This lower level can be adjusted by means of the light
button (G). Press the light button repeatedly till the
desired brightness is reached (three brightness levels
available).
Key lock
In order to avoid accidental operation, you can lock the
keyboard using the keylock function.
To activate this function press buttons + and - together for
at least 3 seconds. The display shows the symbol
a double acoustic signal will be emitted. To disactivate the
function proceed in the same way.

Timer function

This function can be activated in two different ways.
Delayed start: With the appliance off, press the timer
button (F) . The
together with the hours left before the appliance comes on
(see fig. 3). Change the hours using the + and - buttons,
then wait a few seconds for the program to be stored.
The display will return to off and the
on. When the programmed time has elapsed, the appliance
will come on with the previous settings.
Fig. 3
Delayed stop: with the appliance on, press the timer
button . The
with the hours left before the appliance goes off (see fig.
3). Change the hours using the + and - buttons, then wait
a few seconds for the program to be stored. The current
settings and symbol are displayed.
At the end of the set time the appliance switches off
automatically. To go back to operating without the timer,
press the timer button twice.
The timer symbol
Please note: the time is settable from 0.5 to 24
hours.
Change of the temperature scale
The display can show the temperature in both °F and °C.
To select the desired temperature scale, when the unit is in
off position, press and hold the "+" and "ECO" keys for at
least 10 seconds, then release.
The change of scale will be indicated by two short beeps.
Alarms
The appliance has a diagnostic system that makes it
possible to signal malfunctions. In case of problems, the
display will show an alarm message:
13
symbol is displayed flashing
symbols remains
symbol is displayed flashing together
disappears from the display.
and