Sony S-Frame DPF-HD1000 Handbook page 10

To hang the photo frame on a wall
1
Prepare commercially available
screws suitable for the holes on the
rear of the unit.
2
Drive the commercially available
screws into the wall.
Make sure the screws protrude 2.5 mm to 3
mm (approx. 1/8 inch) from the surface of
the wall.
3
Hang the photo frame on the wall by fitting the screw head to the hole
on the rear of the unit.
• Use screws suited for the wall material. The screws may be damaged, depending on the type
of material used in the wall. Drive the screws into a stud in the wall or a pillar.
• Firmly tighten the screw so that the photo frame will not fall from the wall.
• When you want to re-insert a memory card, remove the photo frame from the wall then eject
and re-insert the memory card while the photo frame is placed on a stable surface.
• Remove the stand when you hang the photo frame on a wall.
• Connect the DC cable of the AC adaptor to the photo frame and hang the photo frame on the
wall. Then plug the AC adaptor into the wall outlet.
• Sony takes no responsibility for any accidents or damage caused by defects of attachment,
misuse, natural disasters, etc.
• While the photo frame is mounted on a wall, it may fall if you use buttons on it. We
recommend you to operate it with the remote commander. If you operate the photo frame
from the main unit, support it carefully so as not to drop it.
4 mm (
More than 25 mm (1 inch)
7
Ø 5 mm ( / inch)
32
13
10 mm ( / inch)
32
Holes for hanging the unit
on the wall
Approx.
2.5 mm - 3 mm
1
( / inch)
8
3
/ inch)
16
10
GB