Advertisement
Please read this page before repair the monitor.
The following safety precautions are designed to help you stay safe and prevent accidents during the repair
work.
Please take note of these cautionary flags.
Warning
Caution
Also note these cautionary icons
This means "CAUTION"
This means "POTENTIAL ELECTRIC
SHOCK"
Follow instructions.
The cabinet, chassis, and labels are parts
that require attention. You must follow the
caution notes and safety instructions
presented throughout this User Manual to
prevent damage to them or injury to
yourself.
Prevent electric shock.
Exercise caution while working on the
device as the Monitor contains high
voltage parts and power supply.It is
possible to sustain severe injury or death
if you accidentally touch the wrong
parts.You must disconnect the power
supply while servicing, reassembling, or
change parts. If you touch a live
connection it is possible to sustain severe
injury or death.
Use recommended components.
Use only the recommended components
or componentst that structurally identical
to the originals. This is to ensure safety
and reliability. Pay special attention to
parts in the parts list and circuit diagrams
marked with
non-recommended components, then
electric shock or fire may result.
CAUTION FOR SAFETY
This means "Potential to sustain injury or even death."
This means "Potential to sustain breakage or irreparable damage."
. If you use
This means "MUST"
This means "DO NOT"
WARNING
Must use same types of wires and
components.
The Monitor uses special tubes and tapes
made from insulated materials. Moreover,
some materials are kept from making
contact with the PWB for the sake of
safety.Internal leads are kept from hot
parts or high voltage parts by means of
clamps or other measures. As such, you
must restored these parts to their original
conditions in order to prevent electric
shock or fire.
Perform safety check when done.
Every part (such as removed screws,
components, and wiring) must be restored
to their prior conditions after servicing.Be
sure to check everything that was
repaired for damage or mistakes. Also
measure the insulated impedance with a
meg-ohm meter to confirm that the
impedance value is more than 4M ohm.If
the impedance value is less than 4M ohm,
then electric shock or fire may result.
Do not try to check the HDCP code and
combination circuit.
Never remove the shield case protecting
the HDCP code and combination circuit.
2
Advertisement
