Advertisement
S T E P 4
A.
If tester displayed "Charge & Re-Test", remove battery from tester.
B.
Charge battery based on the chart below.
TIME (MINUTES) TO RECHARGE A SINGLE BATTERY
Voltage
State
Standard
Battery
Charge
6-Volt
12-Volt
6.3
12.6
100%
6.2
12.4
75%
6.1
12.2
50%
6.0
12.0
25%
5.9
11.8
0%
C.
After charging has been completed, retest battery on tester (See Step 3).
D.
If the tester again displays "Charge & Re-Test", warrant battery, following proper warranty procedures.
If tester displays "Bad Cell" or "Replace Battery", warrant battery following proper warranty procedures.
If tester displays "Good Battery", proceed to step 5.
NOTE: CONTACT YOUR ESG OR TOOL EQUIPMENT REPRESENTATIVE FOR
PROPER EQUIPMENT GUIDANCE TO TEST AND CHARGE BATTERIES.
Approx. Battery Charging Time*
To Full Charge at 80°F / 27°C
of
Maximum Rate at
50 Amps
30 Amps
20 Amps 10 Amps
– FULL CHARGE–
20 min.
35 min.
48 min.
45 min.
75 min.
95 min.
65 min.
115 min.
145 min. 280 min. 22.5 hrs.
85 min.
150 min.
195 min. 370 min.
NEVER OVERCHARGE BATTERIES!
EXCESSIVE CHARGING WILL
2 Amps
SHORTEN BATTERY LIFE.
90 min.
7.5 hrs.
* Charging time depends upon
180 min.
15 hrs.
battery age, temperature, capacity,
and efficiency of charger.
30 hrs.
6
IMPORTANT:
Advertisement
