Advertisement
2.Explanation of LED Indicator
The throttle trigger is in neutral position
The throttle trigger is in neutral position
The motor is running while the throttle trigger doesn'
reach to the highest throttle/brake position
The throttle trigger is at the highest throttle/brake position.
■ Programming Card
P ro g ra m m i n g Ca rd a l l ow s yo u to m o d i f y t h e m o s t
commonly used settings in your ESC controller all at the
touch of a single button. No computer needed.
S i m p l y c o n n e c t t h e
P r o g r a m m i n g C a r d t o
t h e t h r o t t l e l e a d o f t h e
controller and power the
p r o g r a m m i n g c a r d a s
described below. Click the
b u t to n to s c ro l l t h ro u g h
and change the indicated
settings. All the settings will
show on the programming
card at once.
Can't get any easier!
■ Programmable Items and Description
Program Item
Cut Off Voltage
Auto-Lipo Cut Off Volts/CELL
Drag Brake
Brakes Strength
Punch Strength
Dead Band
Reverse Type
Moto Timing (Sensor Only)
ESC Type Setting
Moto Direction
Red LED is blinking (zero timing)
Red LED stays on (Motor turbo timing is on)
Instruction for Program Card
●Turn off the ESC.
● C o n n e c t t h e l e a d f r o m p r o g r a m c a r d 's 3 p i n s
connector to the program interface pins of the ESC.
(Please refer ESC's Instruction Manual for details. The
connection methods for different ESC may varies)
●Tu r n on the E SC to apply power to both E SC and
Program Card.
●A l l t h e cu r re nt s et t i n g s w i l l b e d i s p l a ye d o n t h e
correspond LEDs.
●Press and release button to move between settings.
●Press and hold button to change the value for that
setting.
●Turn off the ESC and disconnect lead from Program
Card.
Description
Auto LiPo
None
5V
6V
9V
12V
3.0V
3.1V
3.2V
3.3V
0%-30% (in 5% increment)
0%-100% (in 10% increment)
0-30 (in 5 increment)
Small
Normal
Large
Proportional Rev. Lock Out
Proportional w/o Reverse
FWD to Brake and Reverse
0°-30° (in 5° increment)
ESC Sensor
Normal
Reverse
Green LED is blinking.
Green LED stays ON
Factory Default Setting
10%
80%
10°
Auto
★
★
10
★
★
★
Advertisement
