BRIGHTLUX AL05-100FT-WW-1.5-B Use And Care Manual

TOOLS REQUIRED
Phillips Screwdriver
I
NSTALLATION
MOUNTING THE ROPE LIGHTS
Insert the screw (C) through the opening in the mounting clip (B).
Screw the mounting clip (B) into position at the installation location.
Place the rope light (A) securely into the mounting clip (B).
Mounting clips should be evenly spaced and be a maximum of 3 ft. (0.91 m) apart.
Make sure the distance between two lines of rope light is at least 1/2 in. (12 mm).
S I
AFETY NFORMATION
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
Ground Fault Circuit Interrupter (GFCI) protection should be provided in the circuits
or outlet to be used for outdoor use. Receptacles are available that have built-in GFCI
protection.
Only use outdoor extension cords such as type SW, SOW, STW, STOW, SJW, SJOW, SJTW,
or SJTOW. This designation is marked on the wire of the extension cord.
The rated voltage for this product is 120VAC, 60Hz, 60W, 0.5A.
Do not operate this product with the flexible light tightly coiled.
Do not route the cord or flexible light cable through walls, doors, windows, or any
similar part of a building structure.
Do not subject flexible lighting to continous flexing.
Do not exceed the maximum extension length in feet permitted by the marking. The
maximum extension length for this rope light is 100ft. (30.48 m).
SAVE THESE INSTRUCTIONS
WARNING:
When using this product outdoors,
basic safety precautions should always be followed
to reduce the risk of fire, electric shock, and
personal injury.
WARNING:
This product has a polarized plug (one
blade is wider than the other) as a feature to reduce
the risk of electrick shock. This plug will fit in a
polarized outlet only one way. If the plug does not fit
fully in the outlet, reverse the plug. If it still does not fit,
contact a qualified electrician. Never use with an
extension cord unless the plug can be fully inserted.
Do not alter the plug.
WARNING:
Do not cover this product as the
covering may cause the flexible light to overheat
and either melt or ignite.
Brightlux is a trademark of American Ligthing, Inc.
© 2021 All Rights Reserved.
Use and Care Guide
100ft. LED Rope Light
HARDWARE INCLUDED
100ft. Rope Light
A -
w/5ft. Power Cord x 1
WARNING:
splice the flexible lighting.
WARNING:
the light or cord insulation. Inspect periodically.
WARNING:
light in a manner than can cut the outer jacket or
damage the cord insulation. Inspect the rope light
carefully before use and discard any rope lights
that have a broken outer jacket, loose connections,
or frayed wire insulation.
WARNING:
liquids or use the product in the vicinity of standing
water or other liquids.
WARNING:
hangars or clips provided. Do not secure this product
or its cord with staples, nails, or like means that may
damage the insulation or permanently attach to the
building structure.
WARNING:
1 ft. (4.87 m) of pool or spa. Do not install rope
lighting in cabinets, tanks, or enclosures of any kind.
CAUTION:
you add additional segments. Only use segments
recommended by the manufacturer of this lighting
system.
CAUTION:
cap on the last segment are tightly secured to
prevent the entry of water.
PAGE1
Please contact us at 1-844-255-9692 for further assistance.
Item # 9000-0011
Model # AL05-100FT-WW-1.5-B
B - Mounting Clip x 50 C - Screw x 50
Do not puncture, cut, shorten, or
Do not use if there is any damage to
Do not mount or secure the rope
Do not submerge the flexible light in
Secure this flexible light using only the
Do not install the rope light within
All units must be unplugged before
Ensure all connections and the end