Rinsing, Cleaning And Draining - Royal Sovereign RWD-250W Owner's Manual

Place the water dispenser in an area that is:
• Not humid and has a room temperature less than 26˚C(79˚F).
• Close to an electrical power outlet.
• Away from the heat of direct sunlight and any heating appliance.
• Well ventilated and able to safely support the weight of the water dispenser with a 5 gallon bottle of water fitted.
• Dust and dirt free.
C. SET UP
Do not plug-in the water dispenser into an electrical outlet or turn on the unit until water has begun to dispense from the hot and cold water spots. Failure to follow this warning may
cause the water dispenser to overheat.
Use a clean cloth to wipe the cap and shoulder of the 3 or 5 gallon bottle.
1. Gently place and then lower the 3 or 5 gallon water bottle onto the bottle receptacle (#8). Allow the water to fill the water dispenser and let the water stand for about 2 minutes
2. Wipe off any water which may have splashed on the water dispenser.
3. Plug in the power cord. Turn ON the hot and cold buttons located at the back of the water dispenser (#9,10)
4. Press down on the hot and cold water taps to ensure water flows correctly. Note: It may take a few seconds for the water to initially flow. Allow up to 1 hour for the water to reach the optimal hot
and cold water temperatures.
Cold Water Indicator Light
The green LED indicator light (#3) will be on while the water dispenser is in the cooling process. When the cold water reaches the optimum temperature, the green indicator light will turn OFF. .
Hot Water Indicator Light
The red LED indicator light (#1)will be on while the water dispenser is in the heating process. When the hot water reaches the optimum temperature, the red indicator light will turn OFF.

RINSING, CLEANING AND DRAINING

For best taste and unit performance, it is recommended that the unit be cleaned each time the water bottle is replaced. Use a clean , soft cloth and mild dishwashing liquid.Empty and lean the drip
trip as required. Clean the cold reservoir at least once every 3 months.
DO NOT immerse the water dispenser in water. Avoid abrasive cleaning aids such as steel wool, Do not use bleach.
Before cleaning always unplug the water dispenser from the electrical power outlet.
A. To Clean the Outside of the Unit
Use a disinfectant such as a mild dishwashing liquid and warm water to wipe down the outside of the water dispenser.
-4-