Upgrade Methods - Samsung YP-T10 Service Manual

Troubleshooting
4-2 Upgrade Methods
 If the product does not power on and shows any of the following symptoms, you may try the upgrade methods
in this chapter without having to disassemble the product:
- The product does not turn on when the power switch is pressed.
- The product powers on normally but no USB connection can be made.
- The product's icons appear garbled or malfunction.
- Files are corrupted, or the product shows as a "removable storage" in Windows but cannot be accessed.
4-2-1 Firmware Upgrade Method
1. Download the firmware upgrade file to a folder and decompress it.
2. Check the contents of the folder that was decompressed.
3. Connect the YP-T10 to the PC.
4. Open the Removable Disk folder of the YP-T10.
5. Select the installation file in the folder that was decompressed,
and then copy the upgrade files to the Removable Disk folder
of the YP-T10.
6. Perform "Safely Remove Hardware", and then disconnect the
device from the PC.
7. When power on YP-T10, power off after
"Image Upgrading...", "AUI Upgrading..."
8. Power on again. After "Font Upgrading...",
"Image Upgrading...", "AUI Upgrading..." set will be power
off.
9. After the upgrade, go to "Menu" → "Settings" → "System" →
"Firmware" and check the version.
 If the battery power is low, the upgrade will not start. In this
case, you need to connect a USB or charging cord for the
upgrade to start.
4-14
All manuals and user guides at all-guides.com
Samsung Electronics