Customizable Settings; Limiting The Maximum Output Temperature; Muting The Remote Controller; Flow Meter Alarm - Noritz EZ111 Owner's Manual

Customizable Settings

Limiting the Maximum Output
Temperature
The maximum output
temperature can be limited to
prevent discharging hot water at
too high of a temperature.
Operation
1. The button is OFF.
2. Press and hold the
button until a sound is heard
(approximately 2 seconds).
3. Change the temperature
using the / buttons.
(Setting completed)
(e.g. 120°F)
[For Fahrenheit (°F)]
100 - 140°F (In 5°F intervals)
[For Celsius (°C)]
37 - 48°C (In 1°C intervals),
50 - 60°C (In 5°C intervals)
(Default setting = 120°F/50°C)
• Set the button to ON when
continuing to use the unit as
is. Otherwise, let the unit sit
for approximately 30 seconds.

Muting the Remote Controller

The Remote Controller will
emit a sound when any button
is pressed. This sound can be
muted if it is desired.
Operation
1. Press and hold the
button for 5 seconds.
[Muted]
No sound after 5 seconds
[Sound]
The sounds after 5 seconds
(Default setting = Sound)
• The flow meter alarm cannot
be muted.
• The high temperature warning
tone when setting the unit to
125°F/55°C (131°F) or higher
will not emit a sound when
muted.

Flow Meter Alarm

The flow meter alarm is being
used to indicate when a tub is full.
Operation
1. The button is ON.
• Check the current setting
temperature.
2. Set the temperature using
the / buttons.
3. Press the button, and
adjust with the /
• The flow meter setting will be
blinking.
[For gallon]
10 - 60 gal (In 5 gal intervals),
60 - 100 gal (In 10 gal intervals),
990 gal
[For liter]
40 - 240 L (In 20 L intervals),
240 - 380 L (In 40 L intervals),
990 L
(Default setting = 990 gal (990 L))
• The alarm will not sound if it
is set for 990 gal (990 L).
• The level can only be adjusted
while the flow meter setting is
blinking.
• After 10 seconds, the Remote
Controller will again display
the temperature.
4. Turn on hot water.
• When the tub fills with the
preset volume of water, an
alarm will sound alerting you
to shut off the water.
5. Turn off the hot water when
the alarm sounds to prevent
overfilling.
NOTE • The hot water filling
temperature is
same as the setting
temperature.
• Although the
temperature can be
set to 125°F/50°C
or higher, do not set
the temperature to
125°F/50°C or higher
as it can cause severe
burns instantly or
death from scalding.
Customizable Settings
buttons.
11