Wiring In Pushbuton Controls - Hitachi P1 Basic Instruction Manual

WI RIN G IN PU S HB UT T O N C ON T RO L S
Please use the chart as a reference for connec�ng the pushbuton wires to the corresponding control terminals. Please refer to
supplied electrical schema�c for proper installa�on. Terminals may vary based on model.
2-Step & 3-Step Control Wiring
Pushbuton Wires
Hoist Up Direc�on
Hoist Down Direc�on
Hoist 2 nd
Hoist 3
Micro Speed
Analog 0-10V Potentiometer
Hoist Up Direc�on
Hoist Down Direc�on
Hoist Analog 10V Reference
Hoist Analog Ground Reference
Hoist Analog Input Reference
12/17/2018 Hitachi P1 Closed Loop Hoist Basic Instruc�on Manual Firmware V19 – V25
Speed / 2 nd Step
rd Speed / 3 rd Step
Controller
Cb-05
Cb-06
Control Terminals On Control Panel
110vac to input 6 on interface card
24vdc to input 6 on VFD if no interface card
Break HIC Input 4 (hoist interface card) or input 4 on hoist VFD.
Control Terminals On Control Panel
Terminal H on Hoist VFD
Terminal L botom row on Hoist VFD
Terminal Ai1 on Hoist VFD
Start Rate Of Terminal Ai1
End Rate Of Terminal Ai1
HU
HD
H2
HU
HD
4