sparkfun MicroMod Artemis Processor Board Hookup Manual page 14

With everything setup correctly, upload the code! Once the code finishes transferring, you should see the STAT
LED on the Artemis Processor Board begin to blink!
If the blue LED remains off, it's probably still sitting in the bootloader. After uploading a sketch, you may need
to tap the reset button to get your Artemis MicroMod to run the sketch.
Look at all the blinks!
Example 2: PDM
We've built the Arduino core for Artemis from the ground up and a large number of our built-in examples will work
out of the box with the Artemis MicroMod Processor Board. You'll find them under File->Examples->'Examples
for SparkFun Artemis MicroMod'.
Let's run a quick one from the examples here and take advantage of the two built in microphones on the Machine
Learning Carrier Board we're using. Go to File->Examples->PDM->Example1_MicrophoneOutput
Make sure you have the correct board and port selected, and then upload the code. Once the code finishes
transferring, open the serial monitor and set the baud rate to 115200. You should see something like the
following:
Having a hard time seeing? Click the image for a closer look.
Click above image for full menu context