Cleaning And Maintenance - Remington MicroFlex 200 Use And Care Manual

Microflex R_200_400_IB 8/24/06

Cleaning and Maintenance

To assure smooth, efficient
performance, it is important
to clean your shaver.
Daily
Brush inside the
head assembly
after each use:
1. Turn the shaver
off.
2. Grip the head
assembly by
the three ridges
and pull it off the
shaver.
3. Use the clean-
ing brush to
sweep out the
internal part of
the head assem-
bly and the hair
pocket area,
where 3 shaver
spindles are
located.
4. Replace head assembly.
Weekly
Clean under the cutter assembly at
least once a week:
1. Turn the shaver off.
2. Open the head assembly as above.
3. Unscrew the center screw knob
to remove the cutter retainer
assembly.
4. Use the cleaning brush to sweep
the dust and hairs from under the
cutters.
5. Replace head assembly.
8
All manuals and user guides at all-guides.com
2:34 PM Page 8
Lubricate
Remington ® Shaver Saver ® Lubricant
(SP-4) lubricates and cleans your
shaver's cutters and head assembly.
The lubricant helps remove hair clip-
pings while reducing wear. A quick
spray after each shave keeps your
shaver operating at peak performance.
Important: Make sure to align
!
the two locating holes in the Cutter
Retainer assembly with the pins in
the Head Frame Assembly. (See
illustration below). Then tighten
center screw knob to lock the
cutters into place.
Replace head assembly on the shaver
simply by pushing it onto the shaver.
Cover shaver head with plastic head-
guard between uses. When removing
the headguard or placing it back onto
the shaver,do not apply pressure to
floating cutter surfaces, as you may
damage them.
Cutter retainer
assembly
Center
screw
knob
Locating holes
Head/frame
assembly
Floating
cutter
Locating pins
heads
Cleaning Cautions When is it Time to Replace
The construction of this shaver
Your Heads and Cutters?
is for dry operation only. It is
It is very important to replace your
not waterproof. Never put the
heads and cutters when necessary
shaver partially or completely
to ensure a close, comfortable
into water.
shave without irritation. We recom-
Never clean the shaver or
mend they be replaced every 12
replace the cutters while it is
months. Here are some signs of
plugged into an electrical outlet.
head and cutter wear, indicating
Do not use an aggressive cleansing
that replacement is needed.
agent as this may destroy the
shaver coatings.
Irritation
Do not clean or remove the head
As the heads get excessively worn
assembly while the shaver is running
you may experience some skin
or plugged in, as it may cause dam-
irritation. This would be especially
age to the unit's heads or cutters.
noticeable when you apply
Replace worn or damaged parts
after-shave lotion.
with Remington ® replacement
parts only. Pulling
When the cutters wear you may
feel a sense of pulling and a loss
of closeness when you shave. This
is an indication that it is time to
replace your heads and cutters.
The replacement parts for your
shaver is model SP-25.
U.S. residents: To order, contact
us at 800-231-8793, visit us at
www.remington-products.com
or visit your local retailer.
Canadian residents: For any shaver
accessory requirements, please
call800-268-0425 or visit us at
www.remington-products.com
9