Advertisement
Factory Test & Alignment Specification For MS63F-LA Series (V0.10)
Press RCU "Exit" key exit the Factory menu.
Factory Captions Info.
While "FactoryKey" is enabled, there're some toggled display informations relative to SW,
ProjectID, ADC Status, to facilitate 100% quick screening without accessing to whatever else
menu:
See Appendix
"Factory Menu Description"
2.2. Warm-up Test
Following TCL standard and practices, it's required minimum 15min of Warm-Up that can be
considered as Burn-In.
Additional Aging for White Balance alignment is no more necessary due to consistent Picture
Performance with Cloning usage.
This function is accessible by selecting "Factory menu
key and then leaving Factory menu. Other faster methods are available on above enclosed
SIACP requirements (rev. v3.9).
2.3. White Balance (WB)
White Balance Touch-Up
As some color coordinates discrepancies can be noticed from panel batches to others, it may
necessary to perform slight touch-up.
For Color temperature adjustment, switch TV on leading HDMI input where should be connected
suitable generator providing following format 1280x720p@60Hz test pattern. A 32 steps grey scale is
recommended to assess relevant colorimetry tracking and low/high light saturation points.
Mboot SW
Version
Main SW Version
Project ID
P (Production/Factory mode flag) /
Parser mode flag) / W (Warm-Up mode flag)
WARM-UP", pressing RCU "Zoom+"
Page 8 of 18
S (Factory UART
Advertisement
