TCL X9 Installation Manual

•
Notes:
If the table stand has been assembled, disregard instructions below.
•
Follow the instructions accordingly based on the table stand supplied to you.
•
Graphics contained within this publication are for representation only.
•
Keep the screws and plastic parts away from grease and organic solvents to avoid damage, especially during the assembly process.
•
During installation, lay soft materials below the screen to avoid scratches and damage to the screen.
•
When the TV is faced down, keep sharp edges away from the screen.
What's in the Box:
1 Left Connector 2 Right Connector 3 Stand Plate 4
(X1) (X1) (X1)
8 Left Stand Footpad 9 Right Stand Footpad 10 M3 X 6mm screw
(X1) (X1) (X10)
Prepare a clean, padded surface like a table covered by a soft cloth. The size
1
should be at least 6.5 ft x 4 ft (2 m x 1.2 m). This will prevent scratches and
damages to the TV screen.
Linking Plate 5 Left Stand Bracket 6 Right Stand Bracket
(X1) (X1) (X1)
11 M4 X 6mm screw 12 M4 X 10mm screw 13 M5 X 15mm screw
(X4) (X6) (X18)
2
Open the package, and remove the protection polyfoams as illustrated.
3
Keep the honeycomb panel attached while taking out the TV from the box.
5
7 Bottom Stand Bracket
(X1)
7 Take two buckles out of the TV accessory bag and put them beside buckle A.
Connect the Sound Bar connection cable and TV power cable to the TV and
arrange them well as illustrated.
B
A
TV power cable
Sound Bar connection cable
4
Remove the four magnetic glass covers as illustrated.
Don't press on the screen!
6
8 Put the two connectors at the bottom and get the Sound Bar connection
cable and the TV power cable out through the left connector as illustrated.
Then fix the two connectors with 6 M5X15mm screws.
TV power cable
Sound Bar connection cable