➢
Press "Option" on the remote control and select "Option SettingsNetworkInternet connection". Then
press "OK/►" key to select "On". Wait until the connection is automatically established.
➢
Select "Option SettingsNetworkConnection test", then press "OK/►" to check the Internet
connectivity. If failed, follow below steps to ensure connectivity
➢
Select "Option SettingsNetworkIP settings", then press "OK/►" to enter into "IP settings" submenu
➢
Set "Address type" to "Auto" by pressing "OK/►" key, it will acquire and enter the new detected IP address
automatically
You can also follow below steps to enter your IP address manually
•
Set "Address type" to "Manual" by pressing "OK/►" key, then press "▼" key to go to the first entry field
•
Enter the "IP address", "Subnet mask", "Default gateway", "Primary DNS" and "Secondary DNS"
values. Use remote control digital keys to enter numbers and "◄/►" key to move from one to other field
location
➢
After setting all required inputs, select "Option-->Settings NetworkConnection test" to check the
Internet connectivity again
➢
Select "OptionSettings NetworkInformation", then press "OK/►" key to display current connection
details, such as Interface, Address type, IP address, etc..
Appendix (10) "How to upgrade Flash SW using Network"
Please follow Appendix (10), make sure your TV is connected on the internet.
Update through the menu
➢
Select "Option SettingsSupportSoftware updateBy network", then TV starts to search new
software automatically .If new software is detected, the page will show the button and hint that can guide you.
新建文件夹 (3)Test and Alignment Specification for NT63
Page 19 of 25
Series (v0 01) 170612