Error Codes Chart - GE 27GT530TX1 Technical Service Data

ERROR CODES CHART

Error Code Err Err or Code or Code or Code
Err Err or Code
DEC DEC DEC DEC DEC HEX HEX HEX HEX HEX Err Err Error Location Err Err or Location or Location or Location or Location
0 00 No error code
1 01 16.0V fault
3 03 12.0V run fault
4 04 T4 Chip
8 08 T4 Chip
9 09 T4 Chip (POR)
10 0A F2 PIP module error (POR)
11 0B Stereo decoder (POR)
16 10 Run IIC Bus held low
18 12 Standby IIC Bus held low
23 17 Gemstar Board
24 18 Gemstar Board
25 19 Gemstar Board
34 22 Gemstar Board
44 2C F2 PIP module error
102 66 Octal DAC
128 80 Stereo decoder
160 A0 Main or PIP tuner EEPROM
186 BA T4 Chip
196 C4 Main tuner PLL/DAC
198 C6 Main tuner PLL/DAC
ERR ERROR CODES ERR OR CODES OR CODES OR CODES
ERR ERR OR CODES
If certain failures occur, the matching error codes will be stored in the EEPROM. These error codes will be displayed in parameters 1, 2, and 3. The first failure error code
will be stored at parameter 1 and the second failure error code will be stored at parameter 2. Parameter 3 will be updated to display the most recent failure occurred in the
chassis. If a failure of a bus IC occurred, the normal acknowledgment checking of that bus will be disabled in the service mode and the address of that IC which failed will
be stored in one of the error code parameters. After every repair is done to the chassis it is recommended to check the error code parameters, and reset them back to value 0.
Condition Indicated Condition Indicated Condition Indicated Condition Indicated Condition Indicated
-
16.0V STBY source is failing.
12.0V source is failing.
Run supply failed.
X-ray protection caused high voltage shutdown.
Power supply problem at (POR) power on reset.
Power supply problem at (POR) power on reset/PIP.
Power supply problem at reset/Stereo decoder.
Run IIC clock or data held low.
Standby IIC clock or data held low.
Guide fatal error on set using Gemstar Board.
Task monitor error on set using Gemstar Board.
Watchdog error on set using Gemstar Board.
Gemstar fails to acknowledge.
F2PIP fails to acknowledge.
Octal DAC fails to acknowledge.
Stereo decoder fails to acknowledge.
Main or PIP tuner EEPROM fails to acknowledge.
T4 Chip fails to acknowledge.
Main tuner PLL IC fails to acknowledge.
Main tuner DAC IC fails to acknowledge.
SET 4666 SET 4666 SET 4666 SET 4666 SET 4666 P P Pa a a a a g g g g g e 1 P P e 1 e 1 e 1 e 1