Jonsered 1250RZ Operator's Manual page 39

Place the extra support plates
• Place the extra support plates under the stabiliser leg
plates.
DANGER
Check that the support plates do not bend or sink into the ground!
Crane with tiltable stabiliser legs
1. If the stabiliser extensions are equipped with a
separate lock, unlock it with the handle (2).
2. Make sure the stabiliser extensions are extended a
little, so the stabiliser leg can be rotated freely of the
vehicle.
3. Unlock the stabiliser leg lock (1).
4. To tilt the stabiliser leg use lever or button for stabiliser
leg. Make sure that you have full control of the
movement to avoid risk of crushing.
5. Lock the stabiliser leg lock (1).
6. Extend the stabiliser extension until the yellow mark is
visible. If the stabiliser extensions are equipped with a separate lock, lock it with the handle
(2).
7. Operate the stabiliser leg downwards until it is set to the ground.
Crane with non-tiltable stabiliser legs:
1. If the stabiliser extensions are equipped with a
separate lock, unlock it with the handle (2).
2. Extend the stabiliser extension until the yellow mark is
visible. If the stabiliser extensions are equipped with a
separate lock, lock it with the handle (2).
3. Operate the stabiliser leg downwards until it is set to
the ground.
Starting crane operation
Jonsered 1250RZ -1500RZ safety+R CE 39