Table of Contents
Advertisement
Setting the amount of detergent/softener input
Follow these instructions to increase or decrease the amount of detergent/softener dispensed automatically.
1.
Tap .
2.
Turn the Navigation dial to select Dose Per Wash or Dose Per Rinse.
•
Dose Per Wash: You can select the amount of detergent to input.
•
Dose Per Rinse: You can select the amount of softener to input.
3.
Tap O to change the setting.
•
Default setting is Med. (Medium).
•
You can select from Med., High, Off, or Low.
Setting the water hardness/softener concentration level
1.
Tap and hold
for 3 seconds.
2.
Turn the Navigation dial to select Water hardness or Softener.
3.
Tap O to change the setting.
•
The default setting for water hardness is Med. (Medium), and you can select from Med., Hard, or Soft.
•
The default setting for softener concentration level is 1x, and you can select from 1x, 2x, or 3x.
NOTE
The amount of softener input decreases if you set the concentration level to 2x or 3x.
16
English
U-PJT_WASHER-AD_SimpleUX_MANUAL_DC68-04197G-01_EN.indd 16
Dose per Wash
Eco 40-60
For optimal performance
'OK' to set auto dispense
Water Hardness
Eco 40-60
For optimal performance
OK' to set the hardness level
Med.
Med.
2020-12-24
1:14:35
Advertisement
Table of Contents
