Advertisement
INSTALLATION: QAAD WALL BASIN / BATH SET W/- BACK PLATE
Diagram #1
Mark desired position of wall set and fit screw on left hand side of install plate
With the DOTTED LINE on the wall mixer cover at the 12 O'CLOCK POSITION, use levelling
Diagram #2
tool as shown and mark the right-hand side screw hole
Fit screw on right hand side – check level – fit two additional screws in center for stability
Diagram #3
Diagram #4
Remove PLASTIC GUIDE to complete tiling
Diagram #5
After tiling, push 5MM PLASTIC SPACER over 19BP Elbow (5mm PLASTIC SPACER can be
found in rear of WALL PLATE) – use NIPPLE CUTTER* (see below) to reduce length of 19BP Elbow to a
5MM PROTRUSION FROM THE TILE FACE
Remove 5MM PLASTIC SPACER and assemble CONNECTOR onto the 19BP Elbow – screw
Diagram #6
CONNECTOR up to tile face
Diagram #7
Install WALL PLATE
Diagram #8
Complete assembly by attaching handle and spout as shown
* Recommended NIPPLE CUTTER – Reliance Worldwide Product Code A60-001
FREECALL: 1800 800 919
For all servicing needs, please contact CUSTOMER SERVICE on:
PHONE: 08 6217 0600
www.aldertapware.com.au
FAX: 08 6217 0699
EMAIL: customer.service@aldertapware.com.au
www.vitobertoni.com.au
V05 171017
Advertisement
