Table of Contents
Advertisement
INSTALLATION STEPS:
1) Loosen two screws and remove the cover from the DU 1510 Servo unit to expose the PCB.
2) On the PCB, set DIP SWITCHES (S1-1) to UP to select Solenoid configuration.
3) Remove EndCaps and Enclosure from CT2 box to expose the CT2 PCB.
4) On the PCB, shift the two-position shunt to between Pin1 and Pin2 of J3.
5) Use a #10 or #12 AWG cable to connect 2 wires from Permanent Magnet Motor to CT2 Box
6) Use a #22 AWG cable to connect 3 wires from DU 1510 Box to CT2 Box.
(See the Diagram below).
7) Install a 30A fuse or breaker in line with power input to CT2 Box.
8) Reassemble the units.
1 2 3 4 5 6 7 8 9 10 11 12 13 14
15
16 17 18 19 20 21 22
Figure 7 Connection to 1510 Autopilot
Page 10 of 10
21/09/2007
29010024V3.3(2T Drive Box).doc
Advertisement
Table of Contents
