Installation Steps - Marine ComNav CT2-40A Installation Instructions Manual

INSTALLATION STEPS:

1) Loosen six screws and remove the cover from the DU 1500 Servo unit to expose the PCB.
2) On the PCB, set DIP SWITCHES (S1-1) to UP to select Solenoid configuration.
3) Remove EndCaps and Enclosure from the CT2 box to expose the CT2 PCB.
4) On the PCB, shift the two-position shunt to between Pin1 and Pin2 of J3.
5) Use a #10 or #12 AWG cable to connect 2 wires from Permanent Magnet Motor to CT2 Box..
6) Use a #22 AWG cable to connect 3 wires from DU 1500 Box to CT2 Box. (See the Diagram below).
7) Install a 30A fuse or breaker in line with power input to CT2 box.
8) Reassemble the units.
Figure 6 Connection to 1500 Autopilot
Page 9 of 10
21/09/2007 29010024V3.3(2T Drive Box).doc