During reinstall Flow Sensor
Make sure the flow sensor is not slanting
Make sure arrow point to left
17.9 To Remove Water Pump and Bottle Complete
1. Disconnect CN-PUMP1 from
electronic controller.
2. Loosen the nut.
3. Remove 2 screws.
Water Pump
4. Remove 2 retaining rings, then pull out the water pump.
Bottle Complete
6. Remove 2 retaining rings.
7. Remove 2 screws then remove
bottle complete.
5. Disconnect CN-OLP1 and
lead wire HT1-L3 (Red and White).
198