INSTRUCTIONS
BATTERY REMOVAL AND INSTALLATION
1. Make sure the unit is turned OFF.
2. Locate the battery cover on the
back of the unit. Use a screwdriver
to loosen the screw.
3. If used batteries are present,
remove these batteries from the
unit by pulling up on one end of
each battery.
4. Install 3 new 'AA' (AM-3/LR6)
batteries following the diagram
inside the battery box. For best
performance, alkaline batteries or
fully charged Ni-MH rechargeable
batteries are recommended.
5. Replace the battery cover and
tighten the screw to secure.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.
IMPORTANT: BATTERY INFORMATION
•
Insert batteries with the correct polarity (+ and -).
•
Do not mix old and new batteries.
•
Do not mix alkaline, standard (carbon-zinc) or rechargeable
batteries.
•
Only batteries of the same or equivalent type as
recommended are to be used.
•
Do not short-circuit the supply terminals.
•
Remove batteries during long periods of non-use.
•
Remove exhausted batteries from the toy.
•
Dispose of batteries safely. Do not dispose of batteries in fire.
4